TCL2 Connecting expansion modules to the FOXTROT system (the TCL2 buses with power supply) The following figure .1 shows the basic connection of the expansion modules to the basic module. Peripheral modules are interconnected including the power... TCL2 TCL2 bus installation Individual Foxtrot modules should be connected with cables intended for the RS-485 bus, the minimum of 2 pairs (for the connection of the communication... TCL2 TCL2 bus – the principles of design and installation The peripheral modules on the TCL2 bus (e.g. IB-1301) of one PLC Foxtrot configuration (i.e. all peripheral modules controlled by one basic module) must... RFox RFox router R-RT-2305W The product is no longer for sale The R-RT-2305W router interior module is designed to increase the basic communication range of each radio module. The... RFox RF master RF-1131 The product is no longer for sale The RF master implements communication with RF peripheral modules and transmits the acquired data via the system communication... RFox System functions, configuration, characteristics The communication between the RF master and RF peripheral module is supported for star and mesh topologies. The star topology represents a direct... RFox RFox bus basic parameters The RFox bus (network) is designed to fully comply with the above-stated general authorization. The system is designed to minimize the already massive... RFox RFox bus – principles of design and installation Modules equipped with the RFox interface are no longer available The RFox bus is a wireless radio bus. It is operated in accordance with the general authorization... CIB SPD module of Type 2 DTNVEM 1/CIB and DTNVE 1/CIB If the CIB bus is installed with a risk of excess voltage influence either in the bus itself or in the connected elements (e.g. concurrence with the lightning... CIB CIB surge protection Surge protectors (SPD) for the CIB bus are available: SPD module Type 1+2+3 (the lightning surge suppressor) and Type 2+3 SPD module of Type 2 DTNVEM... … 9 10 11 12 13 14 15 16 17 …